Skip to main content
Viptela is now part of Cisco.
Support
Product Documentation
Viptela Documentation

trap target

snmp trap target—Configure the target SNMP server to receive the SNMP traps generated by this device.

For each trap generated by a Viptela device, the device also generates a notification message. Use the show notification stream viptela command to display these messages.

vManage Feature Template

For all Viptela devices:

Configuration ► Templates ► SNMP

Command Hierarchy

snmp
  trap
    target vpn vpn-id ipv4-address udp-port
      community-name community-name
      group-name name
      source-interface interface-name

Options

Community Name
community-name community-name
Name of an SNMP community configured with the community command.
Group Name
group group-name
Name of a trap group configured with the trap group command.
Interface To Reach Target
source-interface interface-name
Interface to use to send traps to the SNMP server that is receiving the trap information. This interface cannot be a subinterface.
Trap Target
vpn vpn-id ipv4-address udp-port
Location of the SNMP server to receive the trap information. You must specify the following:
vpn vpn-id—Number of the VPN to use to reach to the SNMP server. It can be a value from 0 through 65530.
ipv4-address—IPv4 address of the SNMP server.
udp-port—UDP port number to connect to on the SNMP server. The number can be a value from 1 through 65535.

Operational Commands

show running-config snmp

Example

Configure trap groups and associate them with SNMP trap servers:

vEdge# show running-config snmp 
snmp
 no shutdown
 view v2
  oid 1.3.6.1
 !
 community private
  view          v2
  authorization read-only
 !
 trap target vpn 0 10.0.100.1 162
  group-name     test
  community-name private
  source-interface eth0
 !
 trap target vpn 0 10.0.100.1 16662
  group-name     test
  community-name private
  source-interface eht0
 !
 trap group test
  all
   level critical major minor
  !
 !
!

Release Information

Command introduced in Viptela Software Release 15.2.
In Release 16.2, add source-interface option.

Additional Information

See the Configuring SNMP article for your software release.
show notification stream viptela
trap group

  • Was this article helpful?