Skip to main content
Viptela is now part of Cisco.
Support
Product Documentation
Viptela Documentation

Overview of Configuration Commands

The articles on this page describe the CLI commands that you use to configure the functional network properties of vSmart controllers, vEdge routers, and vBond orchestrators. To configure a Viptela device, you enter configuration mode by issue the config command from operational mode in the CLI. You know that you are in configuration mode because the CLI prompt changes to include the string (config).

In the CLI, configuration commands are organized into functional hierarchies. The top-level configuration hierarchies are:

  • apply-policy—Apply control policy and data policy.
  • banner—Set login messages for the device.
  • bridge—Configure Layer 2 bridging for a rvEdge route.
  • omp—Configure properties for the Viptela Overlay Management Protocol.
  • policy—Configure control policy and data policy.
  • security—Configure IPsec parameters.
  • snmp—Configure SNMP parameters.
  • system—Configure basic system parameters.
  • vpn—Configure the properties of a VPN, including the interfaces that participate in the VPN and the routing protocols that are enabled in the VPN.

To manage a configuration session, use the Configuration Session Management Commands.

​​The articles in this section are arranged alphabetically, by configuration command name. 

  • Was this article helpful?